LaserDistanceLCD: Difference between revisions
No edit summary |
No edit summary |
||
| Line 10: | Line 10: | ||
By the installation place, please note that a device is about 45mm bold, so You have to leave enough place to access the cables and connectors from the sensor and from the programmer. |
By the installation place, please note that a device is about 45mm bold, so You have to leave enough place to access the cables and connectors from the sensor and from the programmer. |
||
The sensor have two mounting holes, 20mm distance. By the mount of the sensor, not that it need to have a clear view to the measured object. Don't install the device in humid environment, water tanks, etc. Also, the device must be used indor, is not made to outdor usage. |
The sensor have two mounting holes, 20mm distance. By the mount of the sensor, not that it need to have a clear view to the measured object. Don't install the device in humid environment, water tanks, etc. Also, the device must be used indor, is not made to outdor usage. Presents of high dust can affect the measurement. The possibility to reflect laser light can affect the measuring range. |
||
Revision as of 10:09, 26 November 2022
Overview
LaserDistanceLCD is a panel-mounted measuring device. It uses laser light to measure the distance between the sensor and the object. The measurement is based on the ToF (time of flight) of light from the source (sensor) and is the reflection (object).
The measured distances can be shown in millimeters (mm) or inches (inch) in 18 different languages. Configuration of a device is made with LaserDistance software.
Hardware installation
The LaserDistanceLCD has to be mounted on a panel. The hole diameters have to be 97 x 72mm. The backside of the device is 45mm deep, so leave enough place to connect the cables. Powering off the device can be done with 220VAC or 110VAC. The sensor is connected with a 1-meter-long flat cable to the device.
By the installation place, please note that a device is about 45mm bold, so You have to leave enough place to access the cables and connectors from the sensor and from the programmer.
The sensor have two mounting holes, 20mm distance. By the mount of the sensor, not that it need to have a clear view to the measured object. Don't install the device in humid environment, water tanks, etc. Also, the device must be used indor, is not made to outdor usage. Presents of high dust can affect the measurement. The possibility to reflect laser light can affect the measuring range.